Content Turbine Blade Steel archives

GTD 450 is a new type of maraging stainless steel. It has a wide application prospect in the additive manufacturing of complex components such as GTD 450 compressor blades using L-PBF technology. In this study, a multi-scale numerical model was used to si

Custom450 is awidelyused maragingstainlesssteel, and the melting method and chemical composition vari ations in different batches have a significant effect on its properties

Custom 450® stainless is a martensitic age-hardenable stainless steel which exhibits very good corrosion resistance with moderate strength. Custom 450 has a yield strength somewhat greater than 690MPa in the annealed condition.

GTD 450 Blades of Gas Turbine Material, UNS S45000, Custom 450® Stainless, Precipitation hardening stainless steel, used for compressor blading.

Metallurgical Analysis and Simulation of a Service-Fractured Compressor Blade Made of ASTM S45000 Alloy

HY-80 is high strength steel used in a quenched and tempered condition to achieve mechanical properties such as ship and submarine hulls

Due to the high efficiency, reduced environmental pollution and high reliab ultra-supercritical coal-fired technology becomes the world leading commercialized power generation technology. The ultra-su

Study and Production of AISI 403 Steel for 300~600MW Turbine Blades

Study on Welding of Steel 17-4PH for Steam Turbine Blades

Steel X10CrNiMoV12-2-2 Forged Bars for Steam Turbine Blades

X5CrNiCuNb16-4 ESR Wrought billets or round bars, for subsequent cold cutting and hot forging into turbine blades

Dynamic recrystallization (DRX) process ofa martensitic stainless steel (AISI 422) at temperatures of950, 1000, 1050, 1100 and 1150oC and strain rates of 0.01, 0.1 and 1 s21.

Mechanical properties of 422 stainless steel repaired via wire feed laser welding

Temperature Measurement and Burn Mechanism of Stainless Steel 1Cr11Ni2W2MoV in Grinding

The steel used in the experiment is 422 martensitic stainless steel, its chemical composition is shown in Table 2.1, and the original heat treatment state is hot-rolled and annealed

Due to supercritical (initial steam pressure of 24MPa, initial steam temperature and reheating temperature of 566°C/566°C) and ultra-supercritical (initial steam pressure of 25MPa, initial steam tempe

Thermoplastic Forming Behavior and Microstructure Evolution of 422 Super-critical Blade Steel

Effects of Tempering Temperature on Microstructure and Low-Temperature Toughness of 1000 MPa Grade NiCrMoV Low Carbon Alloyed Steel

Magnesium rare-earth (Mg-RE) alloy castings with a large size and complex structure exhibit versatile prospects in critical aircraft, aerospace, and defense fields owing to their ultralow density, excellent specific strength, and high-temperature resistan